Not Just for Sheet MetalParts, figure.
A group can be thought of as a ante pokern series of tabs (and slots) along a single edge.
A simple sheet metal part with two solid bodies, each with a different thickness and material specified.In Figure 9 we can see the option for Fillet Edge was chosen and that a radius.040 in was applied.This offset distance is our slot clearance.Click Tools Options Document Properties Dimension to access this option.The Tab Edge will be selected by the user and dictate the component from which the tabs will be extruded, as well as the location of the tabs.(Note: all three methods require the insertion of a non-dimensioned 2X R note pointing at one of the slots end radii.).
With this in mind we have set my tab height to a value.100.
This command allows users to create a boss extrude and pattern (the Tab) on one part and a corresponding cut extrude and pattern (the Slot) on a second part, all in one single command.
Select other options for the center mark type.The final group of options for the Tab and Slot command.There are a lot of options in this property manager and like so many tools in solidworks, if you dont see a preview right away the culprit is usually a bad dimension for the width of the tab or there are too many instances.Select Detailing from the Document Properties tab.This will generate a tab that sticks out from the mating component by a distance.040 in, which will make alignment and welding of the two components a little easier.This is a little misleading because this great new command is not limited to sheet metal parts and can be used in any part type.The slot dimensions appear in the callout.Another accomplishment was making sure SolidWorks supports standard methods for dimensioning slots.In Figure 3 we see a simple part file with two boss extrusions.Select the Document Properties tab.Select the Centerlines/Center Marks page, and select the slot center mark placement options.Lastly, at the outer corner of each tab we can choose to apply a fillet or chamfer, and we can set the desired size of the fillet or chamfer.
Setting Slot Center Marks at View Creation.
In this section we can specify a distance between tabs or the desired number of tabs.
There are three options for edge type:Sharp Edge, Fillet Edge and Chamfer Edge.